Requirements

Make sure you have a USB C Cable that is capable of data transfer.

Don't have a data transfer cable? See Recommended Cables

Select your device

Are you using an RP2350 or RP2040?

CH340?

Are you using a CH340 module?

Input Type

Are you using a mouse or a controller?

Plug the RP device into your PC

Using the USB C Cable, plug the RP2040 or RP2350 into your PC.
Do NOT plug your mouse into the device yet.

Download the activation firmware

Click the download button below.

Enter bootloader mode

While holding BOOT, click RESET, then release BOOT.

Drag and drop the firmware

Drag the .uf2 file into the RP2350 drive.
If you don't see that drive, your USB C Cable might not be capable of data transfer.

Link Device to Account

Connect your RP2040/RP2350 device and click below to link it to your account.

Download mouse firmware

Click the download button below.

Upload the firmware

Upload the firmware the same way you uploaded the last one.

While holding boot, click reset, release boot. Then drag and drop the .uf2 file into the drive.

Plug in your mouse

Plug your mouse into the device and see if it works!
(If you are using an RP2350, click reset after your mouse is plugged in)